one (1) 8 oz bottle of Glass Luster™
one (1) 3M® Scotch-Brite™ Light Duty Cleansing Pad #7445 white color 4"x6" size
additional 3M Scotch-Brite pads are available for purchase.
Glass Luster™ Restoration Cream is an eco-friendly, industrial strength, fine grade cleaning, polishing and water spot removal restoration cream for use on glass, porcelain, tile, chrome, stainless steel and aluminum (not for use on mirrors). It quickly dissolves oxidation, most kinds of spotting and leaves the surface thoroughly clean. It is a magnificent cleaner that leaves no residue deposits. It cleans without etching, scratching or leaving swirls. Glass Luster™ cleans down at the molecular surface area reaching and cleaning within the microscopic hills and valleys in glass. Cleans and restores glass to its original and lustrous shine. Great for use indoors and outdoors.
For Use with:
- Stainless Steel
- do not use on mirrors
Glass Luster™ is easy to apply and deep cleans thoroughly. It is an excellent preparation for the TEKON® protective system and provides a foundation level of cleanliness to apply the TEKON® sealing products. For best results, TEKON® recommends using a white color 3M® Scotch-Brite™ Light Duty Cleansing Pad #7445 together with Glass Luster™.
DIRECTIONS FOR USE
Apply when temperature is between 60°F and 90°F. Do not apply in direct sunlight. Apply generous amount of Glass Luster™ to a 3M® Scotch-Brite™ Light Duty Cleansing Pad #7445. Rub the pad firmly in a small circular pattern over the surface until it is fully renewed. Do a small area at a time. Allow Glass Luster™ to dry until it appears chalky. Buff with a Microfiber Tek Towel.
Optional Cleaning Procedure for Severe Corrosion and Stubborn Stains on Glass Surfaces:
Application with a Vibrating Sander: This is an optional method for severe corrosion and heavily stained glass surfaces. Install the included 3M® Scotch-Brite™ Light Duty Cleansing Pad #7445 onto the vibrating sander and apply Glass Luster™ to the pad. Clean the surface with the vibrating sander from side to side to remove corrosion and stains. If the corrosion is too severe, it can be further restored by adding #0000 steel wool and installing it over the 3M® Scotch-Brite™ pad and the vibrating sander and apply Glass Luster™ to the steel wool pad. Clean the surface with the vibrating sander from side to side to remove corrosion and stains. Let Glass Luster™ dry and wipe off the residue with a Microfiber Tek Towel. CAUTION: If you choose to use an electrical motorized tool, be sure that the floor is completely dry and there are no puddles or running water.
WARNING: Do not inhale. Use in ventilated area.
EYE IRRITANT: Flush eyes with water. If irritation persists, seek medical attention.
SKIN CONTACT: Wash with soap and water.
IF SWALLOWED: Do not induce vomiting. Seek medical attention.
KEEP OUT OF REACH OF CHILDREN